Derustit 2084

Application - direct method

DERUSTIT stainless steel cleaner 2084 is applied undiluted to the surface. This can be done with a brush. It is more advantagous - because of low usage - to spray the stainless steel cleaner evenly onto the surface by using a low-pressure sprayer.

Application - combination method

If welded seams and surfaces are to be treated at one object, the welds should first be treated with a DERUSTIT pickling paste and then, without removing the paste, the surfaces should be treated as mentioned above. In conclusion the object should be thoroughly rinsed with water.

Approx. 6m² surface can be treated with 1 kg DERUSTIT stainless steel cleaner 2084.

We propose a contact time between 30 - 60 minutes.

It is recommended that DERUSTIT stainless steel cleaner 2084 is not allowed to dry before removal. It should not, therefore, be applied to surfaces which are warm or in direct sunlight.

Safety Data

DERUSTIT stainless steel cleaner 2084 contains phosphoric acid. During the processing safety goggles and rubber gloves should be worn. Pay attention to the dangerous hints and safety devices, discribed on the labels of the container.

Effluent treatment

Effluent rinse water resulting from the DERUSTIT stainless steel cleaner 2084 should be neutralised prior to disposal in accordance to the local water authority regulations.

Please note

The information contained in this data sheet is given to the best of our knowledge and is based upon practical and laboratory tests. Our technical service department is willing to offer advice on handling, application and process techniques.